These additives increase the ability of the material to withstand the negative effects of light and UV exposure, thus increasing the service life of the material....
Laminar flow of thermoplastic resins in a mold is accomplished by solidification of the layer in contact with the mold surface that acts as an insulating shell through which molten material flows to fill the remainder of the cavity....
The energy required to break specimens in which there is a v-notched to create an initial stress point....
The energy required to break specimens in which there is a v-notch to create an initial stress point but measured at low temperature (minus 40°C)....
The pressure applied to the cross-sectional area of the molding cylinder....
The process of forming a material by forcing it from a heated cylinder, under pressure, through a sprue into a cavity of a confined mold....
Blow molding process by which the plastic parison to be blown is formed by injection molding....
Are additive used to enhance the material’s ability to withstand the force of impact....
These additives increase the ability of the material to withstand the negative effects of heat exposure. They are used to increase the overall service temperature of the material....
